Skip to content
Huys Houthandel
Isolatie

Insulation

Glass wool, stone wool, PIR, wood fibre.

Insulation keeps warmth in during winter and out during summer, and some of it dampens sound too. At Huys Houthandel you will find insulation for roof, wall, facade and floor: glass wool and stone wool, rigid insulation boards in PIR and XPS, and insulation in wood fibre and wood wool. The vapour barriers come with it.

How well a material insulates is shown by its lambda value (λ): the lower it is, the better it insulates per centimetre. How much a layer insulates, its R-value, depends on that lambda and on the thickness. So if you choose a material with a lower lambda, a thinner layer does the job. Which R-value you need depends on the rules for your project; your architect or EPB assessor will know.

Glass wool and stone wool are mineral wool: soft, springy insulation on the roll or in batts. They fill the space between rafters, studs or joists well. Glass wool comes from 20 to 240 mm thick, for pitched roofs, loft floors, internal walls and facades. The rolls come in widths from 350 to 1200 mm, so you can choose one that fits between your rafters. Stone wool comes on the roll and in batts, and as a rigid board.

PIR boards are rigid foam boards, often with an aluminium foil on both faces. They insulate a lot per centimetre, so a thinner layer does the job. You use them in the cavity wall, on the roof and on the floor. There are square-edged boards and tongue-and-groove boards, from 30 to 160 mm.

XPS is a rigid, pressure-resistant foam board that takes up hardly any water. You choose it where it is damp or where weight bears on it: under a floor, against a basement or foundation wall, in the cavity.

Wood fibre insulation is made of pressed wood fibres. It is heavier than wool or foam, and that helps keep the heat out for longer in summer. There are flexible boards to fit between studs or rafters, and rigid boards for the outside of the roof or wall. Wood wool boards have a rough, visible surface and are often used as a ceiling finish.

For sound between rooms or between homes, there are acoustic boards in glass wool and stone wool, and combination boards of wood fibre faced with OSB, plasterboard or gypsum fibreboard, to insulate and finish in one go.

A vapour barrier is a sheet on the warm side of the insulation. It keeps the moist air from inside your home away from the insulation, so it stays dry and keeps insulating. There are standard PE sheets, vapour barriers that adapt to the humidity, and a fire-retardant vapour barrier.

Insulation is worked out in square metres (m²) per thickness. It comes by the roll or by the pack, and each one states how many m² it holds. For a quote, give us the area, where the insulation goes, the thickness or R-value you need, and the spacing of the rafters or studs if you are insulating between them. Not sure which material suits? Call us and we’ll think it through with you.

Good to know

Glass wool and stone wool
On the roll or in batts, from 20 to 240 mm.
PIR and XPS
Rigid boards, square-edged or tongue and groove.
Wood fibre and wood wool
For roof and wall, and for exposed ceilings.
With vapour barrier
Humidity-adaptive and fire-retardant too.

Tell us what you need.

A question about sizes, quantities or prices? Send us a message or give us a call. We'll think it through with you.